Scarffer

Making Scarf Joints with the Scarffer

The 875 Scarffer circular saw attachment is ideal for working with plywood up to 1/4″ (6 mm) thick, and with minor hand finishing may be used on panels up to 1/2″ (12 mm) thick. Bevels cut with the 875 Scarffer attachment can be more accurate than hand-cut joints, especially if you have little experience making scarfs by hand.

Although there are several different kinds of scarf joints, we advocate using the simplest and most reliable approach, fabricating identical bevels at the ends of the pieces of plywood to be joined. Dry fit these matching bevels, and then permanently bond them with WEST SYSTEM® Epoxy. In many boatbuilding situations, we recommend a ratio of 8-to-1 to determine the size of the bevel. For example, when using 1/2″ (12.5 mm) plywood you need a 4″ long bevel.

The advantage of scarf joints is that they are strong, lightweight, and reduce stress concentrations. In demanding situations, extra strength can be gained by increasing the length of the scarf and they are even less likely to produce a hard spot that could result in an uneven surface when bent. The disadvantage is that fabricating a scarf joint will take more time and skill compared to the butt block and also reduce the length of the plywood.

For making a scarf joint by hand, the basic tools require a block plane and a smoothing plane. Using a power plane or belt sander can save a lot of time in roughing the scarf bevel down close to its intended dimension, but without this luxury use a smoothing plane with a sharp, deep-set blade to remove a majority of the stock as quickly as possible. Then use a more finely set block plane to finish off the scarf bevel, being careful to keep the bevel straight and flat as you proceed. For best results keep the plane blades sharp at all times.

If you have any unevenness on the scarf joint be sure to sand the surface with a hard and flat sanding block. The plane will lose its fine cutting edge quickly when you plane plywood due to the adhesive between plies. The lines created by the various plies in the plywood give a good indication of the progress you are making when creating the bevel. Any humps or unevenness in the bevel usually show up as a crooked line when you sight down the glue line between the laminations. A proper scarf joint is easier to achieve with the Scarffer circular saw attachment. Its accuracy helps you avoid overlapping the pieces when joining plywood.